EPROM-Based 8-Bit Microcontroller with 10 bit ADC The CX8P73B is a low-cost, high speed, high noise immunity, EPROM-based 8-bit CMOS microcontrollers. It employs a RISC architecture with 33 instruct
目录
1.产品概述 2.产品特点 3.应用范围 4.技术规格书下载(PDF文档)</span>
5.产品封装 6.电路原理图</strong> 7.相关产品
The CX8P73B is a low-cost, high speed, high noise immunity, EPROM-based 8-bit CMOS microcontrollers. It employs a RISC architecture with 33 instructions. All instructions are single cycle except for program branches which take two cycles. The easy to use and easy to remember instruction set reduces development time significantly.
The CX8P73B consists of Power-on Reset (POR), Brown-out Reset (BOR), Power-up Reset Timer (PWRT),Watchdog Timer, EPROM, SRAM, tri-state I/O port, I/O pull-high control, Power saving SLEEP mode, 3 real time programmable clock/counter, Interrupt, Wake-up from SLEEP mode, and Code Protection for EPROM products. There are five oscillator configurations to be chosen from, including the power-saving LF (Low Frequency) oscillator and cost saving internal RC oscillator.
The CX8P73B address 1K×14 of program memory.
The CX8P73B can directly or indirectly address its register files and data memory. All special function registers including the program counter are mapped in the data memory.
The CX8P73B provides total 11 channel 10bit AD converter with ±2LSB resolution
Total 11 channel 10bit AD converter with ±2LSB resolution
All instructions are single cycle except for program branches which are two-cycles
14-bit wide instructions
Configurable CPU clock per instruction cycle: Focs/4 and Fosc/2
All EPROM area GOTO instruction
All EPROM area subroutine CALL instruction
8-bit wide data path
6-level deep hardware stack
1K x 14 bits on chip EPROM
27x8 bits on chip special purpose registers and 64 x 8 bits on chip general purpose registers (SRAM)
Operating speed: DC-20 MHz clock input, or DC-100 ns instruction cycle
Direct, indirect addressing modes for data accessing
Three real time down-count Timer with 3-bit programmable prescaler
- TMR1: 8-bit, PWM1(Period) & Timer
- TMR2: 8-bit, PWM1(Duty) & Timer
- TMR3: 8-bit Timer
Built-in 3 levels Low Voltage Detector (LVDT) for Brown-out Reset (BOR)
Power-up Reset Timer (PWRT)
On chip Watchdog Timer (WDT) with internal oscillator for reliable operation.
Two I/O ports IOA, and IOB with independent direction control
- 13 Bi-direction I/O port (Programmable Pull-up enable in Input mode)
- One Input only port (IOB3/RSTB)
Four kinds of interrupt source: 3 Timers, 8 external interrupt sources: IOB0~IOB7, Internal watchdog timer
(i_WDT) wakeup, and A/D end of conversion
Wake-up from SLEEP:
- Port B (IOB0~IOB7) pin change wakeup
- WDT overflow
- i_WDT overflow
Power saving SLEEP mode
Programmable Code Protection
Selectable oscillator options:
- ERC: External Resistor/ Voltage Controlled Oscillator
- XT: Crystal/Resonator Oscillator
- HF: High Frequency Crystal/Resonator Oscillator
- LF: Low Frequency Crystal Oscillator
- IRC: Internal Resistor/Capacitor Oscillator
Wide-operating voltage range:
- EPROM : 2.2V to 5.5V
CX8P73BA : 16-pin EPROM device
CX8P73BB : 14-pin EPROM device
CX8P73BC : 18-pin EPROM device with VR pin
CX8P73BD : 16-pin EPROM device with VR pin
需要详细的PDF规格书请扫一扫微信联系我们,还可以获得免费样品以及技术支持</span>!</p>

七.相关芯片选择指南 更多同类产品......
ADC | |||||||||||||||
Product | ROM | RAM | I/O | Ext. | Int. | Wake | Stack | Timer | PWM / | ADC | LCD | Inter. | IRC | Package | Status |
Name | (Word) | (Byte) | Inte. | Inte. | up | IROUT | |||||||||
2K (OTP) | 128 | 18 | 8 | 7 | Yes | 8 | 8bit*4 16bit*1 | 8bit PWM*2 | 9CH1 | No | No | Yes | DIP/ SOP14 | MP | |
1K (OTP) | 64 | 14 | 8 | 4 | Yes | 6 | 8bit*3 | 8bit PWM*1 | 11CH 10bit+-2 | No | No | Yes | DIP/ SOP14 | MP | |
2K (OTP) | 96 | 22 | 8 | 5 | Yes | 8 | 8bit*3 | 8bit PWM*2 | 8CH 10bit+-2 | SW based 4*17(max) | No | Yes | DIP/ S | MP | |

中文
English
发表评论