CXMD3290 CXMD3290B是一款用于数码相机等的5+1通道H桥电机驱动芯片。它有一个微步进驱动器，两个全摆/恒压驱动器和一个全摆/恒流驱动器。CXMD3290/CXMD3290B可以在串行控制模式或部分外部控制模式下操作。在部分外部控制模式下运行时，每个通道的模式由初始串行控制设置固定。在串行控制模式下工作时，可以通过串行控制设置每个驱动器的模式。
·内置微步进驱动模式可从2-2相步进驱动到最高256分辨率微步进。
内置2个全摆幅/恒压驱动器，通过带制动功能的串行控制进行切换
内置1个恒流驱动器，用于快门或光圈
“低导通电阻（1.2Ω，上下侧导通电阻之和）”，输出电流：各通道输出<=0.8A（最大值）
内置热关机（TSD，150°C）
·所有电源系统（VCC、VM12、VM3、VM45）都可以设置独立的电源
·节电模式对应于串行控制设置
·PI（光断续器驱动）3通道内置。
·采用小28QFn（4×4mm）
·内置POR（上电复位）。
-
[ CXMD3290/B ]"
目录
7.相关产品
产品概述 返回TOP
CXMD3290/CXMD3290B is a 5+1-channel H-Bridge motor drivers IC for the digital camera and so on. It has one micro-stepping driver, two full-swing/constant voltage drivers and one full-swing/constant current drivers. CXMD3290 /CXMD3290B can be operated in serial control mode or partial exterior control mode. When operating in partial exterior control mode, the mode of each CH is fixed by initial serial control setting. When operating in serial control mode, the mode of each driver can be setting by serial control.
产品特点 返回TOP
„ Build-in one micro-steps drive mode is possible from 2-2 phase stepper drive to maximum 256 resolution micro-steps.
„ Built in 2 full-swing/constant voltage drivers switched by serial control with brake function
„ Built in 1 constant current drivers for shutter or IRIS
„ Low on-resistance (1.2Ω, sum of on-resistance of upside and bottom side) „ Output current：IOUT<=0.8A(max.) for each channel
„ Build-in thermal shutdown (TSD, 150°C)
„ All power supply systems (VCC, VM12, VM3, VM45) can be set up with an independent power supply
„ Power save mode corresponds by serial control setup
„ PI (photo interrupter drive) 3 channel built-in.
„ Small 28TQFN (4×4mm) is adopted
„ Build-in POR (power on reset).
应用范围 返回TOP
„ Stepping motor driver/ DC motor driver motor driver for DSC
技术规格书（产品PDF) 返回TOP
需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！
产品封装图 返回TOP
电路原理图 返回TOP
a
相关芯片选择指南 返回TOP 更多同类产品......
|
Motor Driver |
||||||||||
|
Part NO. |
VCC(V min. |
VC(V max. |
VM(V min. |
VM(V max. |
CH |
Build -in PI |
Exterior Control |
Serial Control |
Note |
Package |
|
2.9 |
6 |
2.9 |
5.5 |
6+1 |
3 |
Y CH5~6 |
Y |
CH12&CH34 :Micro Stepping, CH5~CH6: CC/CV/FS |
TQFN5X5-40 |
|
|
3 |
6 |
3 |
6 |
5+1 |
3 |
Y |
Y |
CH12:256-Step MicroStepping CH3~CH4: CV/FS,CH5:CC |
TQFN4X4-28 |
|
|
2.3 |
5 |
-- |
-- |
1 |
-- |
N |
I2C |
CC*1,High active, 10 bit DAC |
TDFN2X2-6 WLCSP2X3-6 |
|
|
2.5 |
5.5 |
-- |
-- |
1 |
-- |
Y |
N |
CC*1 |
SOT23-8 TDFN2X2-8 |
|
|
1.5 |
6 |
2.9 |
6 |
5+1 |
3 |
Y |
Y |
CH1~3:CV/FS,CH5:CC/FS,CH4:CC /CV/FS,CC mode weak excitation |
TQFN4X4-32 |
|
|
1.8 |
5.5 |
-- |
-- |
1 |
-- |
Y |
N |
FS*1 |
WDFN1.6X1.4-6 SOP8/SOP8(FD) |
|
|
2.5 |
6 |
2.9 |
6 |
6+1 |
3 |
Y |
Y |
CH1~4,CH5:CV/FS,CH6:CC/FS, Built-in CC mode weak excitation |
TQFN5X5-40 |
|
|
2.5 |
5.5 |
3 |
5.5 |
4+2 |
3 |
Y |
Y |
CH1~3:CV/FS,CH4:CC/FS CH5:CV/FS |
TQFN4X4-28 |
|
|
2.5 |
6 |
2.9 |
6 |
4+2 |
3 |
Y |
Y |
CH1~3:CV/FS,CH4-4A: CC/CV/FS,CH4-4B:CC/FS |
TQFN3X3-20 |
|
|
2.2 |
5 |
1.8 |
10.5 |
1 |
0 |
Y |
N |
FS*1 |
DIP8/SOP8 |
|
|
2.2 |
5 |
1.8 |
10.5 |
2 |
0 |
Y CH1~2 |
N |
FS*2,2-Channel H-bridge drivers |
DIP16/SOP16 |
|
|
2.5 |
5 |
2.9 |
5 |
4+2 |
1 |
Y |
Y |
CH1~3:CV/FS,CH4:CC/FS CH5:CV/FS |
TQFN3X3-20 |
|
|
3 |
3.6 |
3 |
6 |
5+1 |
3 |
Y |
Y |
CH12:Micro_stepping, CH3~4 :CV/FS,CH5:CC/FS |
TQFN4X4-32 |
|
|
2 |
5 |
2 |
10.5 |
1 |
0 |
Y |
N |
FS*1 |
SOP8(FD) DIP-8 |
|
|
3 |
5.5 |
3 |
5.5 |
8+1 |
2 |
Y |
I2C |
CH1~3&CH5~9:CV/FS, CH4:CC/CV/FS |
TQFN5X5-40 |
|
|
2.5 |
5 |
4 |
16 |
1 |
0 |
Y |
N |
HV FS*1 |
SOP8(FD) TSSOP14 |
|
|
2.5 |
6 |
2.9 |
6 |
5+1 |
3 |
Y |
Y |
CH1~3:CV/FS,CH5: CC/FS,CH4:CC/CV/FS |
TQFN4X4-32 |
|
|
2.5 |
6 |
2.9 |
6 |
5+1 |
2 |
Y |
Y |
CH1~3:CV/FS,CH5: CC/FS,CH4: CC/CV/FS with Chopper Control |
TQFN4X4-44 |
|
