CXLE8169是一款专为白光LED设计的升压型恒流驱动器. 通过内置40V功率管，使得CXLE8169A能驱动单串10LEDs串连负载，从而保证所有LED电流相同。CXLE8169A工作在1.2MHz震荡频率和1.3A电流极限，也能用于通用型的高亮度LED照明。如典型应用电路所示，CXLE8169A回馈电压为200/mV，通过回馈电阻可以设置LED最大输出电流。在工作过程中,EN引脚可以以两种调光方式对CXLE8169A的工作电流进行控制。一是PWM调光方式，通过外加在EN端8KHz 或更高频率的PWM调光信号，PWM调光信号的占空比决定反馈电压的大小。二是数字调光方式，通过在EN端集成一个单线接口，该单线接口可以以32阶调节反馈电压的大小。不管工作在PWM模式还是数字调光模式，CXLE8169A都不会在输出电容上产生音频噪声。其内置38V过压保护功能为LED提供开路保护
-
[ CXLE8169 ]
目录
7.相关产品
产品概述 返回TOP
CXLE8169A是一款专为白光LED设计的升压型恒流驱动器. 通过内置40V功率管，使得CXLE8169A能驱动单串10LEDs串连负载，从而保证所有LED电流相同。CXLE8169A工作在1.2MHz震荡频率和1.3A电流极限，也能用于通用型的高亮度LED照明。如典型应用电路所示，CXLE8169A回馈电压为200/mV，通过回馈电阻可以设置LED最大输出电流。在工作过程中,EN引脚可以以两种调光方式对CXLE8169A的工作电流进行控制。一是PWM调光方式，通过外加在EN端8KHz 或更高频率的PWM调光信号，PWM调光信号的占空比决定反馈电压的大小。二是数字调光方式，通过在EN端集成一个单线接口，该单线接口可以以32阶调节反馈电压的大小。不管工作在PWM模式还是数字调光模式，CXLE8169A都不会在输出电容上产生音频噪声。其内置38V过压保护功能为LED提供开路保护。CXLE8169A采用2mm×2mm TDFN封装，可以节省面积。The CXLE8169A is a constant current step-up converter specifically designed to drive white LEDs. With a 40V rated integrated switch FET, the step-up converter supports up to 10 white LEDs in series connection, so the LED currents are identical for uniform brightness. The boost converter runs at 1.2MHz fixed switching frequency with 1.3A switch current limit, and allows for the use of a high brightness LED in general lighting. The maximum white LED current is set with the external sensor resistor RFB, and the feedback voltage is regulated to 200mV, as shown in the typical application. During the operation, the LED current can be controlled through the EN pin in two modes. With a 8KHz or higher frequency PWM dimming signal on EN pin, CXLE8169A operates in PWM dimming mode, which the duty cycle determines the feedback reference voltage. CXLE8169A can operate in digital dimming mode also, which a Single Wire interface on the EN pin is integrated to adjust the FB voltage in 32 steps. In either digital or PWM mode, the CXLE8169A does not generate audible noises on the output capacitor. For the over voltage protection, the CXLE8169A provides 38V OVP to prevent damage from LED open. The CXLE8169A is available in a space-saving 2mm×2mm TDFN package.
产品特点 返回TOP
‧2.7V～5.5V输入电压
‧38V过压保护
‧集成40VNMOS功率管
‧内置软启动
‧单线协议提供32阶LED电流调节
‧PWM调光频率范围：8KHz~300KHz
‧过温保护
‧输入欠压锁定
‧2mm×2mm TDFN-6封装
‧符合RoHS规范及Pb-Free
2.7V to 5.5 V Input Voltage Range
38V Output Over Voltage Protection
Integrated 40V N-MOSFET
Internal Soft-Start
Single-Wire Serial Pulse Interface to Set LED
Current with 32-Step Scale
External PWM Dimming with 8kHz to 300kHz
Frequency Range
Over Thermal Protection
VIN Under Voltage Lockout
Available in 2mm×2mm TDFN-6 package
RoHS Compliant and 100% Lead (Pb)-Free
Halogen-Free
应用范围 返回TOP
‧移动电话
‧GPS 导航系统
‧便携媒体播放器
‧手持设备、数码相机
‧便携游戏机
Mobile Phones
GPS Navigation Systems
Portable Media Players
Handheld Devices, Digital Camera
Portable Game Machines
技术规格书（产品PDF) 返回TOP
需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！
产品封装图 返回TOP
a
电路原理图 返回TOP
相关芯片选择指南 返回TOP 更多同类产品......
|
白光LED驅動器 > LED背光 |
|||||||||
|
Part Number |
remark |
Vin (V) |
Vout (max)(V) |
FB(V) |
IQ(mA) |
Isw(A) |
Max LED |
Peak Efficency (%) |
Package |
|
Small Package, High Performance, Asynchronies Boost for WLED Driver |
2.6~5.5 |
18 |
0.2 |
0.4 |
2 |
15P3S |
93 |
TSOT23-5 |
|
|
White LED Driver For Buck-Boost Application |
6~25 |
32 |
Vctrl/10 |
1.3 |
1.4 |
3 x 9 = 27 |
90 |
TDFN-8 |
|
|
White LED Boost Converter with PWM Dimming and Single-Wire Interface |
2.7~5.5 |
38 |
0.2 |
0.35 |
1.3 |
12 |
91 |
TDFN-6 |
|
|
10 White LED Boost Converter with PWM Dimming and Single-Wire Series Interface |
2.5 ~ 5.5 |
38.5 |
0.2/0.3 |
0.3 |
1.3 |
12 |
88 |
TSOT23-6,SOT23-6 |
|
|
10 White LED Boost Converter with PWM Dimming |
2.5~5.5 |
38.5 |
0.2 |
0.3 |
1.3 |
12 |
88 |
TSOT23-6 |
|
|
6 String White LED Driver with Boost Converter |
2.5~24 |
43 |
0.5 |
2 |
2.5 |
6 × 10= 60 |
90 |
TQFN-20 |
|
|
4 Strings High Current White LED Driver with Boost Controller |
4.5~28 |
65 |
0.6 |
0.75 |
- |
4 x 18 =72 |
93 |
SOP-16 |
|
|
12 String White LED Driver With Boost Controller |
4.5~28 |
65 |
0.6 |
1.5 |
- |
216 |
93 |
TSSOP-28(EP) |
|
◀ 上一篇:CXLE8161输入电压从2.5V到6V固定1MHz开关频率电流模式和固定频率升压转换器内部软启动电路消除启动过程中的浪涌电流欠压锁定过温保护和电流限制电路
下一篇▶:集成PWM单线调光WLED升压恒流驱动单串10LEDs串连负载保证LED电流相同1MHz震荡频率和1.3A电流极限CXLE8170单线调光在EN端加入符合协议的脉冲信号获得32阶LED电流信号
