• [ CXUS7701H/L ]

样品申请

目录DIQ嘉泰姆

1.产品概述                       2.产品特点DIQ嘉泰姆
3.应用范围                       4.产品封装图DIQ嘉泰姆
5.电路原理图                    6.产品PDF文档 DIQ嘉泰姆
7.功能概述                        8.相关产品DIQ嘉泰姆

一,产品概述(General Description)     DIQ嘉泰姆

     The CXUS7701H/L SmartSwitch is a current limited P-channel MOSFET power DIQ嘉泰姆

switch designed for high-side load switching applications. This switch operates DIQ嘉泰姆

with inputs ranging from 2.4V to 5.5V, making it ideal for both 3V and 5V systems. An integrated current-limiting circuit protects the input supply against large currents DIQ嘉泰姆

which may cause the supply to fall out of regulation. The CXUS7701H/L is also DIQ嘉泰姆

protected from thermal overload which limits power dissipation and junction DIQ嘉泰姆

temperatures. It can be used to control loads that require up to 1A. Current limit DIQ嘉泰姆

threshold is programmed with a resistor from SET to ground. The quiescent supplyDIQ嘉泰姆

 current is typically a low 9μA. In shutdown mode, the supply current decreasesDIQ嘉泰姆

 to less than 1μA.DIQ嘉泰姆

      The CXUS7701H/L is available in a Pb-free 5-pin SOT23 or 8-pin SC70JW packageDIQ嘉泰姆

 and is specified over the -40°C to +85°C temperature range.DIQ嘉泰姆
二.产品特点(Features)DIQ嘉泰姆

Input Voltage Range: 2.4V to 5.5VDIQ嘉泰姆

Programmable Over-Current ThresholdDIQ嘉泰姆
Fast Transient Response:DIQ嘉泰姆
— 400ns Response to Short CircuitDIQ嘉泰姆
Low Quiescent CurrentDIQ嘉泰姆
— 9μA TypicalDIQ嘉泰姆
— 1μA Max with Switch OffDIQ嘉泰姆
145mΩ Typical RDS(ON)DIQ嘉泰姆
Only 2.5V Needed for ON/OFF ControlDIQ嘉泰姆
Under-Voltage LockoutDIQ嘉泰姆
Thermal ShutdownDIQ嘉泰姆
4kV ESD RatingDIQ嘉泰姆
5-Pin SOT23 or 8-Pin SC70JW PackageDIQ嘉泰姆

Temperature Range: -40°C to +85°CDIQ嘉泰姆
三,应用范围 (Applications)DIQ嘉泰姆

 Hot Swap SuppliesDIQ嘉泰姆
Notebook ComputersDIQ嘉泰姆
Peripheral PortsDIQ嘉泰姆
Personal Communication DevicesDIQ嘉泰姆
四,产品封装图 (Package)DIQ嘉泰姆
DIQ嘉泰姆

五,电路原理图DIQ嘉泰姆
DIQ嘉泰姆
六.产品PDF文档 DIQ嘉泰姆

需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！DIQ嘉泰姆

 DIQ嘉泰姆

七,功能概述DIQ嘉泰姆

Operation in Current LimitDIQ嘉泰姆

     When a heavy load is applied to the output of the CXUS7701H/L,the load current is limited to the value of ILIM determined by RSET. See Figure 2, "Overload Operation." Since DIQ嘉泰姆

the load is demanding more current than ILIM, the voltage at  the output drops. This causes the CXUS7701H/L to dissipate a larger than nor-mal quantity of power, and its die temperature to increase. When the die temperature exceeds an over-temperature limit, the CXUS7701H/L will shut down until is has cooled sufficiently, at which point it will startup again.DIQ嘉泰姆

      The CXUS7701H/L will continue to cycle on and off until the load is removed, power is removed, or until a logic  high level is applied to ON. DIQ嘉泰姆

Enable InputDIQ嘉泰姆
    In many systems, power planes are controlled by integrated circuits which run at lower voltages than the power plane itself. The enable input ON of the CXUS7701H/L has low and high threshold voltages that accommodate this condition.The threshold voltages are compatible with 5V TTL and 2.5V to 5V CMOS. DIQ嘉泰姆

Reverse VoltageDIQ嘉泰姆
      The CXUS7701H/L is designed to control current flowing from IN to OUT. If a voltage is applied toDIQ嘉泰姆

 OUT which is  greater than the voltage on IN, large currents may flow. This could cause damage to theDIQ嘉泰姆

 CXUS7701H/L.DIQ嘉泰姆

八,相关产品            更多同类产品......DIQ嘉泰姆

◀ 上一篇:3A持续电流33mW高压侧负载开关CMOS/TTL控制逻辑的内部电平漂移CXUS7736超低静态电流微功率关断电流

返回顶部

下一篇▶:CXUS7702可调电流限制3.5A低电压高性能的单N-MOSFET功率开关全保护功能的电源轨开关控制电荷泵电路热插拔应用软启动

共有条评论 用户名: 密码: 验证码: 匿名发表