5+1CH serial input motor driver IC for DSC CXMD32101 one micro-stepping driver, two full-swing/constant voltage drivers and one full-swing/constant current drivers control mode or partial exterior con

   产品概述 返回TOPYsC嘉泰姆

        CXMD32101 is a 5+1-channel H-Bridge motor drivers IC for the digital camera and so on. It has one micro-stepping driver, two full-swing/constant voltage drivers and one full-swing/constant current drivers. CXMD32101 can be operated in serial control mode or partial exterior control mode. When operating in partial exterior control mode, the mode of each CH is fixed by initial serial control setting. When operating in serial control mode, the mode of each driver can be setting by serial control.

   产品特点 返回TOPYsC嘉泰姆

„ Build-in one micro-steps drive mode is possible from 2-2 phase stepper drive to maximum 1024 resolution micro-steps. YsC嘉泰姆

„ Built in 2 full-swing/constant voltage drivers switched by serial control with brake function YsC嘉泰姆

„ Built in 1 constant current drivers for shutter or IRIS YsC嘉泰姆

„ Built in CH3 DCM FLL function YsC嘉泰姆

„ Low on-resistance (1.2Ω, sum of on-resistance of upside and bottom side) „ Output current：Iout<=0.8A(max.) for each channel YsC嘉泰姆

„ Build-in thermal shutdown (TSD, 150°C) YsC嘉泰姆

„ All power supply systems (VCC, VM12, VM3, VM45) can be set up with an independent power supply YsC嘉泰姆

„ Power save mode corresponds by serial control setup YsC嘉泰姆

„ PI (photo interrupter drive) 3 channel built-in. YsC嘉泰姆

„ Small 32TQFN (4×4mm) is adopted YsC嘉泰姆

„ Build-in POR (power on reset).YsC嘉泰姆

   应用范围 返回TOPYsC嘉泰姆

„ Stepping motor driver/ DC motor driver for DSCYsC嘉泰姆

   技术规格书（产品PDF) 返回TOP YsC嘉泰姆

     需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！YsC嘉泰姆