CXLE8192 The default white LED current is set with the external sensor resistor RSET, and the feedback voltage is regulated to 200mV, as shown in the typical application. During the operation, the LED

   产品概述 返回TOPEkq嘉泰姆

With a 40V rated integrated switch FET, the CXLE8192 is a boost converter that drives LEDs in series. The boost converter runs at 600kHz fixed switching frequency to reduce output ripple, improve conversion efficiency, and allows for the use of small external components.Ekq嘉泰姆

Ekq嘉泰姆

The default white LED current is set with the external sensor resistor R_SET, and the feedback voltage is regulated to 200mV, as shown in the typical application. During the operation, the LED current can be controlled using PWM signal through the CTRL pin. The duty cycle of pulse width modulation (PWM) signal determines the feedback reference voltage. In PWM mode, the CXLE8192 does not burst the LED current; therefore, it does not generate audible noises on the output capacitor. For maximum protection, the device features integrated open LED protection that disables the CXLE8192 to prevent the output voltage from exceeding the IC’s absolute maximum voltage ratings during open LED conditions.Ekq嘉泰姆

Ekq嘉泰姆

The CXLE8192 is available in Green TDFN-2×2-6L and TSOT-23-6 packages. It operates over an ambient temperature range of -40℃</span> to +85℃</span>.Ekq嘉泰姆

   产品特点 返回TOPEkq嘉泰姆

• Input Voltage Range: 2.7V to 20V
• 38V Open LED Protection
• 200mV Reference Voltage
• 500kΩ Pull-Low Resistor on CTRL Pin
• PWM Brightness Control
• 1kHz to 100kHz PWM Dimming Frequency Range
• Soft-Start Function
• Up to 90% Efficiency
• -40℃</span> to +85℃</span> Operating Temperature Range
• Available in Green TDFN-2×2-6L and TSOT-23-6
    PackagesEkq嘉泰姆

   应用范围 返回TOPEkq嘉泰姆

Cellular Phones
Portable Media Players
Ultra Mobile Devices
GPS Receivers
White LED Backlighting for Media Form Factor DisplayEkq嘉泰姆

   技术规格书（产品PDF) 返回TOP Ekq嘉泰姆

     需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持</span>！</span>
Ekq嘉泰姆