高效同步升压调节器CXSU63038A6A功率MOSFET带锂电池输入输入欠压闭锁6A峰值电流限制集成软启动

CXSU63038A高效同步升压调节器，可转换为2.5V输入电压和5.5V输出电压。主开关采用NMOS，同步开关采用PMOS CXSU63038A是一种高效的同步升压调节器低至2.5V输入，高达5.5V输出电压。主要采用动校正同步开关的开关和PMOS。它可以断开输出在关机模式下输入

目录

1.产品概述                       2.产品特点
3.应用范围                       4.下载产品资料PDF文档 
5.产品封装图                     6.电路原理图                   
7.功能概述                        8.相关产品

 

一,产品概述(General Description)         
        CXSU63038A is a high efficiency synchronous boost regulator that converts 

down to 2.5V  input and up to 5.5V output voltage. It adopts NMOS for the main 

switch and PMOS for the synchronous switch. It can disconnect the output from

 input during the shutdown mode.. It integrates 6A power MOSFET and can 

output 5V 2.5A with Li-Battery input.
二.产品特点(Features)
2.5V Minimum input voltage
Adjustable output voltage from 3V to 5.5V
6A peak current limit
Input under voltage lockout
600Khz fixed Switching Frequency
Load disconnect during shutdown
Integrated soft-start
Output over voltage protection
30mojtm Power MOSFET
Thermal Shutdown
SOP8-PP Package
三,应用范围 (Applications)
Handheld Devices
Power Bank
All Single Cell Li or Dual Cell Battery Operated Products
四.下载产品资料PDF文档 

---

需要详细的PDF规格书请扫一扫微信联系我们，还可以获得免费样品以及技术支持！

 

五,产品封装图 (Package)

---

PIN NUMBER	PIN NAME	PIN DESCRIPTION
1	Vbat	VDD Power Supply，need one 1uF MLCC close to VBAT pin and AGND
2	EN	Shutdown control input., Connect this pin to logic high level to enable the device
3	AGND	Analog ground
4	FB	Feedback pin
5	Vout	DC-DC Boost output
6,7	SW	Switch pin , Connect an inductor between IN pin and LX pin.
8	PGND	Power ground
9	EPAD	GND and Thermal Pad

六.电路原理图

---

七,功能概述

---

The controller circuit of the device is based on a fixed frequency multiple feedforward
controller topology. Input voltage, output voltage, and voltage drop on the NMOS switch are
monitored and forwarded to the regulator. So changes in the operating conditions of the
converter directly affect the duty cycle and must not take the indirect and slow way through
the control loop and the error amplifier. The control loop, determined by the error amplifier,
only has to handle small signal errors. The input for it is the feedback voltage on the FB pin,
the voltage on the internal resistor divider. It is compared with the internal reference voltage
to generate an accurate and stable output voltage.
The peak current of the NMOS switch is also sensed to limit the maximum current flowing
through the switch and the inductor. The typical peak current limit is set to exceed 6A. An
internal temperature sensor prevents the device from getting overheated in case of
excessive power dissipation.
八,相关产品            更多同类产品........    

---

内置MOS同步DC-DC升压IC
型号	工作模式	电压范围	输出电压	输出电压形式	输出电压精度	输出电流限制	效率	静态电流	工作频率	封装
CXSU63033	PWM	0.9V-5.0V	最大5.5V	可调输出	+/-2%	950mA	90%	0.1uA	1.4MHz	SOT-26
CXSU63033A	PWM	0.85V-5.0V	最大5.0V	可调输出	+/-2%	2A	93%	0.1uA	1.5MHz	SOT23-6
CXSU63034	PWM	0.85V-5.5V	2.5V-5.5V	可调输出/真关断	+/-2%	1.2A	94%	300uA	1.2MHz	SOT23-6
CXSU63035	PWM	2.5V-4.5V	最大6V	可调输出	+/-2%	3.3A	93%	100uA	1MHz	ESOP-8
CXSU63036	PWM	2.4V-6.0V	2.5V-5.3V	可调输出/真关断	+/-2%	6A	91%	180uA	500KHz	ESOP-8
CXSU63037	PWM	2.5V-5.25V	2.5V-5.5V	可调输出	+/-2%	8A	90%	45uA	500KHz	ESOP-8
CXSU63038B	PWM	2.8V-5.0V	最大5.5V	可调输出	+/-2%	4A	91%	180uA	550KHz	ESOP-8
CXSU63038A	PWM	2.5V-6.0V	最大5.5V	可调输出/真关断	+/-2%	6A	90%	0.5uA	1.2MHz	SOP8-PP
CXSU63039	PWM	2.5V-5.5V	最大5.5V	可调输出/真关断	+/-2%	6A	90%	0.5uA	1.2MHz	QFN4X4-16L
CXSU63040	PWM	1.8V-6.0V	最大5.5V	可调输出/真关断	+/-2%	6A	90%	0.5uA	1.2MHz	SOP8-PP
CXSU63041B	PWM	1.8V-5.25V	2.5V-5.5V	可调输出	+/-2%	5A	97%	10uA	500KHz	QFN2X2-10