一,产品概述(General Description)         
         The JTM6118 series are highly accurate, low noise,
LDO Voltage Regulators that are capable of providing an
output current that is in excess of 1A with a maximum dropout voltage of 1.3V at 1A （ JTM6118A33） .This series contains
four fixed output voltages of 1.2V, 1.8V, 2.5V and 3.3V that
have no minimum load requirement to maintain regulation.
On chip trimming adjusts the reference/output voltage to within ±2% accuracy.Internal protection features consist of output
current limiting, safe operating area compensation,and thermal shutdown. The JTM6118series can  operate with up to 18V input. Devices are available in SOT223.

二.产品特点(Features)
Output Current in Excess of 1A
1.)Dropout Voltage:80mV@ IOUT =100mA
（JTM6118A33）
2.)Operating Voltage Range: 2.5V～18V
3.)Highly Accuracy: ±2％
4.)Adjustable Output Voltage Option
5.)Standby Current: 52uA（TYP.）
6.)High Ripple Rejection: 70dB@1KHz（JTM6118A33）
7.)Line Regulation: 2mV（TYP.）
8.)Temperature Stability≤0.5%
9.)Thermal Shutdown Protection：160℃
10.)Packages:SOT223 ,SOT89-3,TO252-2L，SOT23-3

三,应用范围 (Applications)
Consumer and Industrial Equipment Point of
Regulation
Switching Power Supply Post Regulation
Hard Drive Controllers
Battery Chargers

四.下载产品资料PDF文档 

JTM6118

五,产品封装图 (Package)

六.电路原理图


七,功能概述
Applications Information
1. Input Bypass Capacitor
An input capacitor is recommended. A 10uF tantalum on the input is a suitable input bypassing for almost all
applications.
2. Output Capacitor
The output capacitor is critical in maintaining regulator stability, and must meet the required conditions for both
minimum amount of capacitance and ESR (Equivalent Series Resistance).The minimum output capacitance
required by the JTM6118 is 10µF,if a tantalum capacitor is used. Any increase of the output capacitance will
merely improve the loop stability and transient response. The ESR of the output capacitor should be less than
0.5Ω .
3. Load Regulation
The JTM6118 regulates the voltage that appears between its output and ground pins, or between its output and
adjust pins. In some cases, line resistances can introduce errors to the voltage across the load. To obtain the
best load regulation, a few precautions are needed. Figure1, shows a typical application using a fixed output
regulator. The Rt1 and Rt2 are the line resistances. It is obvious that the VLOAD is less than the VOUT by the sum of
the voltage drops along the line resistances. In this case, the load regulation seen at the RLOAD would be
degraded from the datasheet specification. To improve this , the load should be tied directly to the output terminal
on the positive side and directly tied to the ground terminal on the negative side.
八,相关产品

LDO IC
型号	最大输	输入电压	输出电压	精度	功耗	负载	线性	封装形式	状态	替代型号
	出电流					稳定率	稳定率
JTM6206	300mA	7.0V	1.2/1.5/1.8/2.0/2.1/2.2	2%	7uA	40-80mV	0.05%	SOT-23	量产	XC6206
			2.5/2.8/3.0/3.3/3.6/5.0V					SOT-23-3L		RT9166
								SOT-89		RT9169
										AIC1734
										AIC1722
JTM6214	500mA	8.0V	1.8/2.5/2.8/3.0/3.3/	2%	5uA	12-30mV	0.05%	SOT-89	量产	XC6214
			3.6/4.2/5.0V							APL5885
带使能LDO IC
型号	最大输	输入电压	输出电压	精度	功耗	负载	线性	封装形式	状态	替代型号
	出电流					稳定率	稳定率
JTM1134	500mA	6.5V	1.2/1.5/1.8/2.5/	2%	静态电流：40uA	0.6%	0.4%	SOT-25	量产	XC6204B/
			2.8/3.0/3.3/5.0V		关断电流：1uA					XC6219B/
										XC6221/
										RT9167/
										AIC1742/
										RT9193/
										LP2985/
										PT5107
JTM6219	300mA	6.5V	1.2/1.5/1.8/2.5/	2%	静态电流：25uA	65dB	0.20%	SOT-25	量产	XC6219B/
			2.8/3.0/3.3/3.6V		关断电流：1uA					XC6221/
JTM6210	700mA	8.0V	1.2/1.8/2.5/2.8	2%	静态电流：30uA	15mV	0.01%	SOT-25	量产	XC6210
			3.0/3.3/3.6V		关断电流：1uA			SOT-89-5L
JTM6230	3A	6.0V	0.8-VIN	2%	10uA	0.10%	0.20%	ESOP8	量产	ME966/A
										APL5930
										APL5920
										RT9018
										RT9025
双路带使能LDO IC
型号	最大输	输入电压	输出电压	精度	功耗	负载	线性	封装形式	状态	替代型号
	出电流					稳定率	稳定率
JTM6401	300mA	10V	1.8+2.8/1.8+3.3/	2%	静态电流：25uA	50mV	0.01%	SOT-26	量产	XC6401/
			2.8+3.3/2.8+1.8V		关断电流：0.11uA					PT5127/
										EUP7201/
										AP6401/1
										SGM2207
JTM9182	300mA	10V	2.8+1.8/3.3+1.8/	2%	静态电流：25uA	50mV	0.01%	SOT-26	量产	RT9182/
			1.8+2.8V		关断电流：0.11uA					RT9011/
										PT5128
可调输出LDO IC
型号	最大输	输入电压	输出电压	精度	功耗	负载	线性	封装形式	状态	替代型号
	出电流					稳定率	稳定率
JTM6205	300mA	6.0V	可调，最低0.9V	±2%	静态电流：57uA	50mV	0.1%	SOT-25	量产	AP2127
					关断电流：1uA					AP2128
										PAM3103
										SGM2019
JTM6215	500mA	6.0V	可调，最低0.8V	±1.5%	静态电流：40uA	0.60%	0.08%	SOT-25	量产	AP2127/8
我司的JTM6204BXX2MR/SOT-25有如下优点：
1.最大可达300mA负载电流，耐电流可达500mA.
2.工作电压2.5-6.5V,耐压可达7V.
3.静态电流小，压差小，纹波小,带载能力和抗干扰能力强。
4.可广泛用于手机/MID/MP3&MP4&MP5/蓝牙/数码相机/GPS/点读笔/音响/液晶电视/电表/电子钟表/电子玩具等各类电子产品市场。
5.目前我司产品有出在三星/LG等著名品牌的手机产品上的（手机的要求是比较高的），在带载能力、纹波、静态电流、抗干扰、压差等各方面参数都要优于目前市场上国内同类产品的。目前市场上很多国内同类产品是进不了手机市场的，性能参数达不到要求的。
产品应用：
1.MP3/MP4/MP5/PMP 播放器
2.MID/UMPC
3.GPS/行驶记录仪
4.PDVD/车载DVD/汽车音响
5.液晶电视/液晶显示器
6.移动电源/电子烟
7.小家电、家电控制板