|
目录
一,产品概述(General Description)  The JTM2234 is a fully in tegrated , high-efficiency 2.0A synchronous rectified step-down converter. The JTM2234 operates at high efficiency over a wide output current load range.
This device offers two operation modes,PWM control and PFM Mode
switching control, which allows a high efficiency over the wider range of the load.The rber of readily available standard external components and is available in an 6-pin SOT23 ROHS compliant package. 二.产品特点(Features) * High Efficiency: Up to 95% * 600KHz Frequency Operation * 2.0A Output Current * No Schottky Diode Required * 3.5V to 18V Input Voltage Range * 0.6V Reference Slope Compensated Current Mode Control for Excellent Line and Load Transient Response * Integrated internal compensation * Stable with Low ESR Ceramic Output Capacitors * Over Current Protection with Hiccup-Mode * Input over voltage protection(OVP) * Thermal Shutdown * Inrush Current Limit and Soft Start * Available in SOT23-6 Package * -40°C to +85°C Temperature Range 三,应用范围 (Applications) Distributed Power Systems Digital Set Top Boxes Flat Panel Television and Monitors Wireless and DSL Modems Notebook Computer 四.技术规格书下载（产品PDF）
 六.电路原理图  七,功能概述 Internal Regulator The JTM2234 is a current mode step down DC/DC converter that provides excellent transient response with no extra external compensation components. This device contains an internal, low resistance, high voltage power MOSFET, and operates at a high 600K operating frequency to ensure a compact, high efficiency design with excellent AC and DC performance. Error Amplifier The error amplifier compares the FB pin voltage with the internal FB reference (VFB) and outputs a current proportional to the difference between the two. This output current is then used to charge or discharge the internal compensation network to form the COMP voltage, which is used to control the power MOSFET current. The optimized internal compensation network minimizes the external component counts and simplifies the control loop design. Internal Soft-Start The soft-start is implemented to prevent the converter output voltage from overshooting during startup. When the chip starts, the internal circuitry generates a soft-start voltage (SS) ramping up from 0V to 0.6V. When it is lower than the internal reference (REF), SS overrides REF so the error amplifier uses SS as the reference. When SS is higher than REF, REF regains control. The SS time is internally fixed to 1 ms. Over-Current-Protection and Hiccup The JTM2234 has cycle-by-cycle over current limit when the inductor current peak value exceeds the set current limit threshold. Meanwhile, output voltage starts to drop until FB is below the Under-Voltage (UV) threshold, typically 30% below the reference. Once a UV is triggered, the JTM2234 enters hiccup mode to periodically restart the part. This protection mode is especially useful when the output is dead-short to ground. The average short circuit current is greatly reduced to alleviate the thermal issue and to protect the regulator. The JTM2234 exits the hiccup mode once the over current condition is removed. Startup and Shutdown If both VIN and EN are higher than their appropriate thresholds, the chip starts. The reference block starts first, generating stable reference voltage and currents, and then the internal regulator is enabled. The regulator provides stable supply for the remaining 八,相关芯片选择指南
(责任编辑：oumao18) |
|||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
粤ICP备13004986号-3