Operation in Current Limit
     When a heavy load is applied to the output of the JTM4610,the load current is limited to the value of ILIM determined by
RSET. See Figure 2, "Overload Operation." Since the load is demanding more current than ILIM, the voltage at the output
drops. This causes the JTM4610 to dissipate a larger than nor-mal quantity of power, and its die temperature to
increase. When the die temperature exceeds an over-temperature limit, the JTM4610 will shut down until is
has cooled sufficiently, at which point it will startup again.
      The JTM4610 will continue to cycle on and off until the load
is removed, power is removed, or until a logic high level is
applied to ON.
 
Enable Input
       In many systems, power planes are controlled by integrated circuits which run at lower voltages than the power plane
itself. The enable input ON of the JTM4610 has low and high threshold voltages that accommodate this condition.
The threshold voltages are compatible with 5V TTL and 2.5V to 5V CMOS.