当前位置: 主页 > 新闻中心 > 行业新闻 >

The JTMA8728 is a single-phase, constant on-time, synchronou(3)

时间:2015-10-23 09:45来源:未知 作者:oumao18 点击:
recommended. Below is a checklist for your layout: Keep the switching nodes (UGATE, LGATE, BOOT,and PHASE) away from sensitive small signal nodes since these nodes are fast moving signals.Therefore, k

recommended. Below is a checklist for your layout:
· Keep the switching nodes (UGATE, LGATE, BOOT,and PHASE) away from sensitive small signal nodes
since these nodes are fast moving signals.Therefore, keep traces to these nodes as short as
Layout Consideration (Cont.)
 
possible and there should be no other weak signal traces in parallel with theses traces on any layer.
· The signals going through theses traces have both high dv/dt and high di/dt with high peak charging and
discharging current. The traces from the gate drivers to the MOSFETs (UGATE and LGATE) should be short
and wide.
· Place the source of the high-side MOSFET and the drain of the low-side MOSFET as close as possible.
Minimizing the impedance with wide layout plane be-tween the two pads reduces the voltage bounce of
the node. In addition, the large layout plane between the drain of the MOSFETs (VIN and PHASE nodes) can
get better heat sinking.
· The PGND is the current sensing circuit reference ground and also the power ground of the LGATE low-
side MOSFET. On the other hand, the PGND trace should be a separate trace and independently go to
the source of the low-side MOSFET. Besides, the cur-rent sense resistor should be close to OCSET pin to
avoid parasitic capacitor effect and noise coupling.
· Decoupling capacitors, the resistor-divider, and boot capacitor should be close to their pins. (For example,
place the decoupling ceramic capacitor close to the drain of the high-side MOSFET as close as possible.)
· The input bulk capacitors should be close to the drain of the high-side MOSFET, and the output bulk capaci-
tors should be close to the loads. The input capaci-tor’s ground should be close to the grounds of the
output capacitors and low-side MOSFET.
· Locate the resistor-divider close to the FB pin to mini-mize the high impedance trace. In addition, FB pin
traces can’t be close to the switching signal traces (UGATE, LGATE, BOOT, and PHASE)

八,相关产品
 Part_No   Package & Pins   Topology   Architecture   Phase   No. of PWM Outputs   Output Current (max)(A)   Input Voltage (V)   Reference Voltage(V)   Bias Voltage (typ) (V)   Quiescent Current (typ)(uA) 
min max
JTMA7068 SOP-14 Buck VM 1 1 30 2.9 13.2 0.9 12 8000
QSOP-16
QFN4x4-16
JTMA7065 SOP-8 Buck VM 1 1 20 2.9 13.2 0.8 12 5000
JTMA7065C SOP-8 Buck VM 1 1 20 2.9 13.2 0.8 12 5000
JTMA7098 QFN4x4-24 Multiphase VM 2 1 60 3.1 13.2 0.6 12 5000
JTMA7120 SOP-8 Buck VM 1 1 20 2.2 13.2 0.8 5月12日 2100
JTMA7120A SOP-8 Buck VM 1 1 20 2.2 13.2 0.8 5月12日 2100
JTMA7037/A/B SOP-8 Buck VM 1 1 5 5 13.2 1.25 / 0.8 5月12日 3000
TSSOP-8
JTMA7057 SOP-8 Buck VM 1 1 10 3.3 5.5 0.8 5 2100
JTMA7062B SOP-14 Buck VM 1 1 10 5 13.2 0.8 12 2000
JTMA7066 TSSOP-24 Buck VM 1 2 20 5 13.2 0.6 5月12日 4000
QFN5x5-32
JTMA7067N SOP-14 Buck VM 1 1 30 2.9 13.2 0.9 12 4000
QSOP-16
QFN-16
JTMA7073 SOP-14 Buck VM 1 1 30 2.2 13.2 0.6 12 5000
JTMA7073A SOP-14 Buck VM 1 1 30 2.2 13.2 0.6 12 5000
JTMA7074 SOP-14 Buck VM 1 1 25 2.2 13.2 0.8 12 5000
JTMA7095/A LQFP7x7-48 Buck VM 1 6 0.015 1.4 6.5 - 5 1800
TQFN7x7-48 Boost
  Flyback
JTMA7116 TSSOP-24P Buck VM 1 2 20 2.97 5.5 0.8 5月12日 5000
JTMA7063 SOP-14 Buck VM 1 1 10 5 13.2 0.8 12 3000
JTMA7064 SOP-8-P Buck VM 1 1 30 2.9 13.2 1.2 12 3000
DIP-8
JTMA7108 SSOP-28 Buck VM 1 2 20 5 24 0.9 5 1200
QFN4x4-24
JTMA7158 SOP-20 Buck VM 1 2 20 2.2 13.2 0.6 5月12日 4000
JTMA7181 SOP-8   VM 1 2 - - - - 5月12日 550
DFN3x3-10
JTMA38HC/42/3/4/5A DIP-8 Buck VM 1 1 1 1.2 9 24 5 9 ~ 24
SOP-8 Boost
  Flyback
  Forward
JTMA7138 SSOP-16 Buck VM 1 1 25 3 25 0.6 5 1700
QFN4x4-16
TQFN3x3-16
JTMA7199 TDFN3x3-10 Buck COT 1 1 25 3 25 0.5 5 350
JTMA8700 QFN4x4-24 Buck CM 2 1 40 4.5 13.2 0.6 5月12日 4000
JTMA8720B SOP8-P Buck VM 1 1 20 3 13.2 0.8 5月12日 2500
TDFN3x3-10
JTMA8722A/B/C/D SOP8-P Buck VM 1 1 25 3 13.2 0.6 /0.8 5月12日 1200
JTMA8723 TDFN3x3-10 Buck VM 1 1 25 4 13.2 0.8 5月12日 2000
JTMA8724 TDFN3x3-10 Buck COT 1 1 25 4.5 25 0.6 5月12日 80
JTMA8725/A SOP-8P Buck VM 1 1 25 4.5 13.2 0.8 5月12日 16000
JTMA8726 TQFN3x3-10 Buck VM 1 1 25 4.5 13.2 0.6 5月12日 2500
JTMA8727/L TDFN3x3-10 Buck COT 1 1 30 3 25 0.8 5月12日 2000
JTMA8728 TQFN3x3-16 Buck COT 1 1 30 1.8 28 0.6 5 600
JTMA8732 QFN4x4-24 Buck VM 2 1 50 4.5 13.2 0.6 5月12日 5000
JTMA8811 TQFN4x4-24 Buck COT 1 2 15 6 25 2 N 550
JTMA8812 TQFN4x4-24 Buck COT 1 2 15 6 25 2 N 550
JTMA8813/A TQFN4x4-24 Buck COT 1 2 20 3 28 0.75 5 800
TQFN3x3-20
JTMA8814 TQFN3x3-16 Buck COT 1 1 20 1.8 28 0.75 5 400
JTMA8815 QFN3.5x3.5-14 Buck COT 1 1 20 1.8 28 0.75 5 400
TQFN3x3-16
JTMA8816 TQFN3x3-16 Buck COT 1 2 20 1.8 28 0.75 5 400
JTMA8819 QFN3x3-20 Buck COT 1 2 20 3 28 1.8 /1.5 /0.5 5 740
TQFN3x3-16
JTMA8820 TQFN4x4-24 Buck CM 1 2 15 5 28 0.5 N 3000
QFN3x3-20
JTMA8821 TDFN3x3-10 Buck COT 1 1 20 1.8 28 0.5 5 250
JTMA8822/C TQFN3x3-20 Buck COT 1 2 15 6 25 2 N 550
JTMA8823A/B TQFN3x3-20 Buck COT 1 2 15 5.5 25 0.6 N 50
JTMA8868 TQFN3x3-20 Buck COT 1 2 20 3 28 0.75 5 180
JTMA7088 QFN4x4-24 Multiphase VM 2 1 60 3.1 13.2 0.85 12 5000
JTMA7165A/B/C SOP-8P Buck VM 1 1 20 2.9 13.2 0.8 12 16000
JTMA7159A SOP-20 Buck VM 2 2 30 10 13.2 1 12 5000
JTMA8828 TDFN3x3-10 Buck COT 1 1 25 1.8 28 0.7 5 250
JTMA8728 TQFN 3x3 16 Buck COT 1 1 30 1.8 28 0.6 5 600

(责任编辑:oumao18)
顶一下
(0)
0%
踩一下
(0)
0%
------分隔线----------------------------
尚未注册畅言帐号,请到后台注册
栏目列表
推荐内容